Introduction to the advantages of clamp type fluorine lined butterfly valve and elastic soft seal gate valve

Precision cast valve body
　　 check valve The valve body is precision cast, and its geometric dimensions ensure the sealing of the valve without any precision machining inside.
lightweight
This valve is made of ductile iron casting, which reduces the weight by about 20% -30% compared to traditional gate valves. Easy installation and maintenance.
Whole package adhesive
The valve plate is made of high-quality rubber for the overall inner and outer packaging. Domestic rubber vulcanization technology ensures that the vulcanized valve plate can maintain the geometric dimensions, and the rubber is firmly connected to the ductile iron gate plate, which is not easy to fall off and has good elastic memory.
corrosion-resistant
The valve body is coated with powder foam epoxy resin, Fluorine lined DC globe valve It can prevent corrosion and rust of the valve body and can be used in sewage systems.
Not easily broken
In the past, traditional cast iron gate valves often suffered from breakage caused by external objects hitting, colliding, or overlapping. Due to the use of ductile iron in this valve, this situation can be significantly reduced.
Flat bottomed valve seat
Traditional gate valves often accumulate in the groove at the bottom of the valve due to external objects such as stones, wooden blocks, cement, paper scraps, debris, etc. after flushing with water. It is easy to cause leakage due to the inability to close tightly. The low part of the soft seal gate valve adopts the same flat bottom design as the water pipe, which is not easy to cause debris accumulation and ensures unobstructed fluid flow.
Three O-ring seals
Due to the use of a three "0" ring sealing design for the valve stem, PTFE lined valve It can reduce the frictional resistance during switching and significantly reduce water leakage. The sealing ring can be replaced without stopping the water supply during construction.
Helps with drinking
Due to the non-toxic epoxy resin coating inside the valve body, the inner and outer surfaces of the gate are covered with rubber to prevent rust or corrosion, making it suitable for drinking.

The article is written by Fluorine lined valve factory Provided, please indicate when reprinting http://www.lierduofm.com/