Fluorine lined check valve manufacturer says MOTION is a motion simulation CAE plugin

check valve The manufacturer says that MOTION is a motion simulation CAE plugin

MOTION is its motion simulation CAE plugin, which can establish a three-dimensional dynamic simulation mechanism model and add motion, constraints, forces, collisions, etc., simulate the mechanism, perform interference analysis, track the motion trajectory of parts, and perform clamp type Fluorine-lined Butterfly Valve Analyze the speed, acceleration, force, reaction force, and torque of components in the analysis mechanism, and output various forms of results such as animations, graphics, and tables. The analysis results can guide the modification of component structural design or adjustment of component materials.

The specific movement process: The power of the pneumatic valve is transmitted from the spindle, which drives the cam and pushes the piston rod to the left, causing the left sealing space to become smaller. This increases the pressure of the gas, and the spring inside the pipe joint will also release high-pressure gas due to the increase in internal pressure, thus achieving the pressure sent out by the pressure valve.

When the top of the cam is located in the opposite direction, the piston rod will compress the thrust of the spring and move to the right, increasing the left sealing space and allowing gas to enter through the lower pipe joint.

Click on the tool options and select the MOTION option in the menu. The specific steps are as follows:

1） PTFE lined valve For the convenience of later cam mechanical cooperation operations, open the part cam, click on the dividing line tool, select the reference plane to make a sketch, and divide the contact surface between the cam and the piston rod into four contact surfaces.

2) Similarly, for the coordination of the cam surface, open the piston rod of the component, select the reference surface to sketch and add stretching features. Be careful not to check the merge entity option, as it will generate two entities. Right click on the newly generated rectangular entity to hide it.

3) Open the assembly, and the system will display a dialog box for rebuilding. Click OK to delete the spring part, create a new reference plane, build the spring, add relationships, and then save the spring to make it associated.

The article is written by Fluorine lined valve factory Provided, please indicate when reprinting http://www.lierduofm.com/